Which port to use on EKM Omnimeter Pulse v.4

General questions and discussions focused around the EKM Metering System. Discuss your meters, installations, and meter communications here.
Post Reply
209
Posts: 6
Joined: Tue Dec 22, 2015 8:30 am

Which port to use on EKM Omnimeter Pulse v.4

Post by 209 »

I want to connect one 3/4" Water Meter to an Omnimeter Pulse v.4. Which port should I connect the water meter to?

Apologies if this has been asked before?

c
Jameson
Posts: 860
Joined: Fri Nov 04, 2011 7:42 pm
Location: Santa Cruz, CA
Contact:

Re: Which port to use on EKM Omnimeter Pulse v.4

Post by Jameson »

Here is a page in our support documents that should help you: https://help.ekmmetering.com/support/so ... s-metering

This is a quote from that page:
"For Pulse Input 1, connect the pulse output wire from a water meter or gas meter to port 13 on the Omnimeter Pulse v.4 and the ground wire to port 14 on the Omnimeter Pulse v.4"

Here is the spec sheet for the 3/4" Water Meter: http://documents.ekmmetering.com/EKM-SP ... -sheet.pdf

Here is a quote from that page:
"Connect the red wire from the water meter to either port 11, 12, or 13.
Connect the black wire to port 14."

Hope this helps.
Jameson
EKM METERING
http://www.ekmmetering.com
831.425.7371
Post Reply