Running Dash software on ReadyNAS

General questions and discussions focused around the EKM Metering System. Discuss your meters, installations, and meter communications here.
Post Reply
Phil_C
Posts: 1
Joined: Thu Feb 26, 2015 12:35 pm

Running Dash software on ReadyNAS

Post by Phil_C »

Hello
I am looking into running the linux version of the dash software on an a Debian/Linux Netgear ReadyNAS storage system. The reason is it is the only computer in my network that is on 24/7. Is there any way the Dash can be run on Debian? Currently I get an error when uploading dash to the nas that states "Error: Only Debian Package is Allowed".

Regards

Phil
Jameson
Posts: 860
Joined: Fri Nov 04, 2011 7:42 pm
Location: Santa Cruz, CA
Contact:

Re: Running Dash software on ReadyNAS

Post by Jameson »

Hello Phil,

Im sorry I dont really know what that means (Im not a Linux guy). I know the Dash has been run on Debian, check this out:

http://forum.ekmmetering.com/viewtopic. ... inux#p5777

go to the end and then go here:

http://forum.ekmmetering.com/viewtopic. ... 5902#p5902

So I think it is possible, but dont have much guidance except for what Dandelot had found referenced in the links above.

Let us know if you get it sorted out.
Jameson
EKM METERING
http://www.ekmmetering.com
831.425.7371
Post Reply