Thermal Metering

Forum is open to all questions, answers, and discussions related to all other types of meters not listed above, ours or others.
Post Reply
INTELLECTRIC
Posts: 2
Joined: Wed Nov 25, 2020 6:40 am

Thermal Metering

Post by INTELLECTRIC » Fri Jan 22, 2021 8:40 am

Do you have any recommendations for a thermal meter that would feed pulses into a v.4 Omni? There are a number that have their own controller, and many communicate on Modbus, but are you aware of any that would provide a straight pulse output that could be configured on the dashboard?

Thank you,

Jameson
Posts: 793
Joined: Fri Nov 04, 2011 7:42 pm
Location: Santa Cruz, CA
Contact:

Re: Thermal Metering

Post by Jameson » Fri Jan 22, 2021 9:27 am

We don't have any direct experience with BTU/Heat Meters that have a pulse output. But here are some links to get you started:

https://www.onicon.com/products/system-20-btu-meter/
http://www.heatcombustion.co.uk/product.asp?i=518
https://www.diehl.com/metering/en/portf ... 775/63755/

If you can find a pulse output BTU/Heat Meter, it should work with our Omnimeter Pulse v.4 for pulse counting. You can then connect the Omnimeter Pulse v.4 to the internet using the EKM Push system.
Jameson
EKM METERING
http://www.ekmmetering.com
831.425.7371

INTELLECTRIC
Posts: 2
Joined: Wed Nov 25, 2020 6:40 am

Re: Thermal Metering

Post by INTELLECTRIC » Tue Feb 02, 2021 9:26 am

One of EKM's competitors, Intellimeter, out of Pickering, ON Canada (https://intellimeter.com/products/btu-meters) has a range of BTU meters with M-Bus, Modbus-485, and optional pulse interface. If I go down this road, I will update the thread!

Post Reply