Do you have any recommendations for a thermal meter that would feed pulses into a v.4 Omni? There are a number that have their own controller, and many communicate on Modbus, but are you aware of any that would provide a straight pulse output that could be configured on the dashboard?
Thank you,
Thermal Metering
Re: Thermal Metering
We don't have any direct experience with BTU/Heat Meters that have a pulse output. But here are some links to get you started:
https://www.onicon.com/products/system-20-btu-meter/
http://www.heatcombustion.co.uk/product.asp?i=518
https://www.diehl.com/metering/en/portf ... 775/63755/
If you can find a pulse output BTU/Heat Meter, it should work with our Omnimeter Pulse v.4 for pulse counting. You can then connect the Omnimeter Pulse v.4 to the internet using the EKM Push system.
https://www.onicon.com/products/system-20-btu-meter/
http://www.heatcombustion.co.uk/product.asp?i=518
https://www.diehl.com/metering/en/portf ... 775/63755/
If you can find a pulse output BTU/Heat Meter, it should work with our Omnimeter Pulse v.4 for pulse counting. You can then connect the Omnimeter Pulse v.4 to the internet using the EKM Push system.
-
- Posts: 2
- Joined: Wed Nov 25, 2020 6:40 am
Re: Thermal Metering
One of EKM's competitors, Intellimeter, out of Pickering, ON Canada (https://intellimeter.com/products/btu-meters) has a range of BTU meters with M-Bus, Modbus-485, and optional pulse interface. If I go down this road, I will update the thread!