New water meter install with EKM Push
Posted: Wed Jan 27, 2016 2:10 am
I know these questions have likely been addressed by other posters, but I need to have these interesting products and services by EKM reinforced in my mind. So bear with me if these are a little redundant!
To start, once the EKM Push Gateway is wired to the pulse output of the water meter, and then the EKM Push is connected to my router in my home, where does my pulse data show up next​? Do I have to use EKM Dash software? Is it automatically send to your cloud servers?
Also do I have to have an Omnimeter connected to the EKM Push or is that a separate device used for other purposes?
I'm thinking it would be useful to just have the raw data available on a cloud server, and manipulate the data into some specific user-generated graph for water-use analysis.
Can I do this with the hardware, EKM Push gateway only, without needing to hook up your Omnimeter?
To start, once the EKM Push Gateway is wired to the pulse output of the water meter, and then the EKM Push is connected to my router in my home, where does my pulse data show up next​? Do I have to use EKM Dash software? Is it automatically send to your cloud servers?
Also do I have to have an Omnimeter connected to the EKM Push or is that a separate device used for other purposes?
I'm thinking it would be useful to just have the raw data available on a cloud server, and manipulate the data into some specific user-generated graph for water-use analysis.
Can I do this with the hardware, EKM Push gateway only, without needing to hook up your Omnimeter?