default pulse counting ratio on v.4 Omnimeter
Posted: Sun Aug 10, 2014 12:42 pm
I don't have an RS485 adapter so I can access the settings on my new v.4 Omnimeter, which I'm using to monitor an EKM gas pulse meter. I can't get the meter to register the pulses from the gas meter and I'm assuming it's because the ratio setting isn't 1:1 like I expected. I figured this out based on what I read in this thread.
http://forum.ekmmetering.com/viewtopic.php?f=10&t=3323
Until I get an RS485 adapter to check the settings, what is the default ratio the v.4 Omnimeter is set to on the pulse reading inputs?
http://forum.ekmmetering.com/viewtopic.php?f=10&t=3323
Until I get an RS485 adapter to check the settings, what is the default ratio the v.4 Omnimeter is set to on the pulse reading inputs?